Signature San Marcos Concrete & Masonry

Masonry Contractor in Temecula, CA - Walls, Pavers and Stone Built for Your Lot

Signature San Marcos Concrete & Masonry builds and repairs block walls, retaining walls, stone veneer, pavers and brick for homes in Temecula, CA. We're based in San Marcos and work across Temecula, from tract streets to hillside lots.

A stone outdoor kitchen counter with pale tops stands on a tiled patio beside a pond and lawn.
  • Licensed and insured.
  • Free quotes on site.
  • We respond within 1 business day.

Masonry work in Temecula

Much of what we're called out for in Temecula is in the newer neighborhoods. Block walls run between tract yards, stone veneer covers the lower part of stucco fronts, and backyards often step down a slope behind a retaining wall. Old Town's historic buildings call for a different approach, since any repair there has to match the old work. The tract-yard calls are much like the ones we get next door in Murrieta, and the block wall work isn't far off what we do down in El Cajon.

So many of these homes sit on graded lots that I start most jobs by looking at what's under the wall and where the water goes, because that usually decides whether a crack needs new block or a fix underneath.

What we build and repair in Temecula

What Temecula lots ask of a wall

The city designs structures to Seismic Zone 4 values, so a new wall here is built to take shaking, not just to stand straight. For block and retaining walls that usually means steel and grout in the block's hollow cells and a footing sized to the wall. On an existing wall, I check the cracks and the lean before I tell you whether a repair is worth doing.

A lot of what we see on tract lots is a yard wall that's started to lean or crack, and the cause is usually soil and water pushing from the uphill side, not bad block. Price and timing turn on what's under the wall, how easy the yard is to reach and whether the city needs to review the work first.

Get a free on-site estimate for your Temecula project

Tell us what you'd like built or fixed and the property's address, and I'll reply within one business day. I come out myself, look at the job and write a free estimate, with no pressure to book.

Temecula masonry questions

How do I get a building permit for masonry work in Temecula?

You apply through the City of Temecula's online Permit Center, where Building and Safety handles plan check, permits and inspections for work inside city limits. The city asks you to confirm the property is inside city limits, and grading and right of way permits go through its Land Development Division instead. If your job needs a permit, we check with the city at the start and take care of the paperwork with you.

Does a contractor from outside Temecula need a city business license?

Yes. The city requires a business license from anyone doing business inside Temecula city limits, and contractors based outside the city apply separately. Every city business license runs out on January 31, so it's fair to ask any contractor, us included, whether theirs is current. We're based in San Marcos, so this is the license that applies to us.

When does a contractor need a California state license for a job in Temecula?

The state licensing board says a license applies when the project needs a building permit, uses any additional workers, or when labor and materials on the project add up to $1,000 or more. A license isn't needed only when all of these hold: no permit, no employee labor, a combined cost under $1,000 and no claim in advertising to be licensed. We're licensed and insured.

How do I make sure inspections happen on my Temecula project?

The city makes the property owner responsible for getting every required inspection done, though the contractor may schedule them and be on site. Work has to stay open and visible until a building inspector approves it, and the permit, approved plans and job card need to be on site for each inspection. We plan the work around those visits so a footing or the steel in a wall isn't covered before the inspector sees it.

What building codes apply to a block or retaining wall in Temecula?

The city requires every structure to be designed and built in full compliance with its municipal code, which adopts the California building codes. It also publishes design values for building here, including a wind speed of 97 mph and a rainfall rate of 3 inches per hour, and those are figures for designing a structure, not weather readings. That rainfall figure is why I give drainage behind and under a retaining wall as much attention as the block itself.

What affects the cost of a masonry wall or patio in Temecula?

Size and material move the price most, because natural stone and brick take more hand work than block and a taller retaining wall needs a deeper footing and more steel. Repairs add the time it takes to match old mortar, and tearing out an old wall adds demolition and hauling. I write the estimate on site after looking at the job, so the figure is for your wall and not a guess over the phone.

Have a wall or patio in mind?

Describe the project and its address, and I'll come out, look it over and write you a free estimate.

Other areas we serve

If your city is listed below, its page covers our work there, and if it isn't, call (760) 304-1464 because we work in many cities around San Marcos.